Higher productivity

Published:  23 September, 2016

Sandvik_hollow_bar_-_Copy.jpgSANDVIK reports it launched new generation Sanmac at IMTS in September, offering a stainless steel material which can significantly increase machining rates.

Sandvik says year on year its research and development has applied and tested process improvements upgrading the melt of Sanmac material and the result is the introduction of new generation Sanmac, a dedicated stainless steel material available in a range of grades that not only offer machinability at similar rates to carbon steel, but also exhibit excellent chip breaks and have consistent machinability from heat to heat and lot to lot, thus greatly reducing operator set up times.

“With new generation Sanmac, machining speeds of up to 240 m/min are achievable as a result of the material’s consistency.” says product manager Viktor Stefansson.

w: www.smt.sandvik.com/en/products/bar-and-hollow-bar/hollow-bar/

Click here for the full unedited version of the release as provided by the company

Sign up for the PWE newsletter

Latest issue

To view a digital copy of the latest issue of Plant & Works Engineering, click here.

View the past issue archive here.

To subscribe to the journal please click here.

Poll

"How is your manufacturing business preparing for a net Zero target?"






Twitter